Thermador professional

Thermador Professional Oven PG366BS/07:
i seek your Knowledge as i love to fix my own equipment ( even if it takes me a heck of a long time). Problem:
Oven starts, bake and convection bake modes- tries to climb to set temp most time does not get there and temp retreats to 0. blue heating light still on .
Oven starts, broil mode - ingnitors on broiler burners turn, burners with gas on for 30 seconds then cycle Off.
i have shut power to unit at breaker panel a few times and it seems to...

Read more

via Thermador professional
by oliver connelly

Bosch cooktop electrode malfunction

Hello,
I have the Bosch Gas Cooktop NGMP655UC. By the way, I would not recommend buying a cooktop from Bosch. The unit is 4 years old and the screws attaching the burners to the top are all corroded and the 2 screws I tried to remove just snapped.
I have the following issue with the cooktop. Of the 5 burners, the 4 in the corners are working fine - they light up when you turn the knob, and then the igniter goes off. With the central burner (the one we use most because it's the only one...

Read more

via Bosch cooktop electrode malfunction
by asquare

Please help opening/debugging Thermador Professional and igniters

Hi, I can really use your help to fix the igniters on our “Thermador Professional” 6-burner gas cooktop.

The house we moved into has an old gas cooktop, 6 burners. I've looked everywhere for a model number and I cannot find it, but it looks like this:

View attachment 55770

View attachment 55771

Gas flows normally to all burners and I can light them all with a match.
The front and back burners share a single igniter, so there are 3 igniters.
The igniter can...

Read more

via Please help opening/debugging Thermador Professional and igniters
by lewinr

EH3012SCH Dacor, Replace control board

I got my control board replacment and removed the front 4 screws from the top panel. I can't easily get it to come down. It seems blocked by the back panel. Dacor's manual has no such diagram or instructions for how these interlock. Any ideas?

via EH3012SCH Dacor, Replace control board
by mendozer

Thermador wall oven SMW272YW relay replacement part number needed

Broiler will come on but not the bake element. Circuit board not available so it's either fix the board or replace the whole oven. Problem is probably a power relay: Omron G8P-UA-006206, is 30A 250VAC. I can't find a replacement and apparently Omron doesn't make one with this part number any more. Another forum post gave a replacement relay for a very similar relay ending in 006203 for a Frigidaire wall oven. The new number is G8P-1A4 ... something like that. Difference is in the coil...

Read more

via Thermador wall oven SMW272YW relay replacement part number needed
by Ann Leddy Harris

Older Sears gas oven 50 degrees off with new sensor

Hi thanks for reading.

I have an older Sears gas range / oven with an electronic arrow up & down oven control panel. I have replaced the temp sensor that sit completely (screws are also) inside the oven, Wires go through the oven wall to the back. Others, I know most are mounted on the outside back wall of the oven, not this one.

The calibration is only 35 degrees which leave the reading 15 to 20 degrees low. Read 370 at 350 actual average temp. The temp swings are limited to 10 degrees...

Read more

via Older Sears gas oven 50 degrees off with new sensor
by m5gorrf

YRMF3130VM2 McClary Oven Overheating

Hello,

My 20yo+ McClary oven started overheating recently, and when I opened up the back panel I saw that one of the contacts on the thermostat had partially melted.

The part doesn't seem to made available anywhere online. Maybe there are some repair shops in the area that would have it, but is there a universal replacement part I could get instead?

This is all I've found: amresupply.com/part/12326948

via YRMF3130VM2 McClary Oven Overheating
by Psychokinesis