I just wanted to sanity check my Samsung oven, which we bought 11 months ago. A few recipes came out a little under, so we bought a thermometer to hang on it. There was a 25 degree discrepancy, which we recalibrated. Here's an example:
Precalibration:
Set to 400
Preheat to 400
+10 minutes later, drop to 375. Stays that way for the next hour.
Post-calibration: +25 degrees
Set to 400
Preheats to 425 actual
+10 minutes, settles to 400 degress. Stays that way for the next hour.
Just wanted to sanity check that this is normal and the initial overage of 25 degrees isn't anything to be worried about.
Also, the preheat beep actually goes off about 5 minutes before it hits the target temp even though the thermostat says (for example) 400. So I'll set it to 400, it beeps ready and shows 400, but the independent thermometer will show 325 or so. Then if I wait 3-5 minutes, it goes all the way to 400 before doing the drop issue above.
This is under warranty for three more weeks, so I wasn't sure if I should have it looked at or if this is all pretty standard stuff.
Precalibration:
Set to 400
Preheat to 400
+10 minutes later, drop to 375. Stays that way for the next hour.
Post-calibration: +25 degrees
Set to 400
Preheats to 425 actual
+10 minutes, settles to 400 degress. Stays that way for the next hour.
Just wanted to sanity check that this is normal and the initial overage of 25 degrees isn't anything to be worried about.
Also, the preheat beep actually goes off about 5 minutes before it hits the target temp even though the thermostat says (for example) 400. So I'll set it to 400, it beeps ready and shows 400, but the independent thermometer will show 325 or so. Then if I wait 3-5 minutes, it goes all the way to 400 before doing the drop issue above.
This is under warranty for three more weeks, so I wasn't sure if I should have it looked at or if this is all pretty standard stuff.
via Samsung Oven NX58J5600SGAA Preheat/Stead State Questions
by bswb
No comments:
Post a Comment